Operating Instructions -
11
ENGLISH
Carefully lift the monitor out of the packaging and make
sure that all components are included (see fi g. 1).
Save the original box and packing material in case you
have to ship or transport the monitor.
±
Assembling the monitor base ................................
1.
To attach the base, place the monitor face down on
a fl at surface.
2.
Fold the stand upwards and slide the base onto the
stand until it clicks into place.
3.
Then fold out the assembled base completely so that
you can place the device upright.
UNPACKING
Power cord
Audio cable
Figure 1.
LCD Monitor
VGA cable
MENU
SELECT
VOLUME
MUTE
AUTO
±
To connect the monitor to your PC .........................
1.
Make sure that the PC and monitor are unplugged.
2.
Connect the 15-pin signal cable to the monitor and
the PC (see fi g. 2).
CONNECTING
±
Connecting the audio cable ....................................
If your computer is equipped with an audio output port,
then connect one end of the sound cable to the audio
input connector of the monitor (
in fi g. 3) and the other
end to the Line-Out connector of the computer.
±
To connect the monitor to the power source ........
Connect the separate power cable (
in fi g. 3) to the
monitor and a grounded outlet.
±
Headphone connector .............................................
If you own headphones, you may connect them to the
monitor’s headphone connector (
in fi g. 3).
AC-IN
D-SUB
Figure 3.
Connecting the monitor to the power source
1
Figure 2.
Connecting the monitor to the PC
Signal cable
AC-IN
D-SUB
3
2
1.
First start your PC and then turn on your Belinea
monitor using the power switch (
in fi g. 4). The
status indicator (
in fi g. 4) should light up green.
2.
Adjust the image to meet your requirements (see the
following sections “Basic Setup” and “Image settings
using the OSD menu”).
3.
If there is no image displayed on the monitor, consult
the section “Troubleshooting”.
STARTUP
