Voice Encryption
The voice encryption can encrypt your audio signals to guarantee the privacy of
your communication, via the programming software user can select encryption
type as static or dynamic. If the encrypt feature is enabled, the transmitter and
receiver will be set as the same encryption type and same encryption key,
otherwise the receiver is mute.
Via programmable software to set it: General Settings folder →Voice Encryption
Type→ Voice Encryption Key
Note: This feature is effective on digital channel.
Dual Capacity Direct Mode
If enable TDMA direct mode, the members in the same group call must use the
same slot, one frequency supports calls in two slots synchronously in order to
avoid interfering communications in the other slot.
Via programmable software to set it: Channels folder→Zone→a digital channel
or A/D Channel→TDMA Bypass Mode→Slot Align→Slot→Pseudo Trunk TX
Slot
Note: This function is available only in digital operation.
Radio Priority-Based Interrupt
The call priority feature allows you to interrupt the on-going call on current
forcibly, a preemptive call can interrupt other on-going calls with lower priority to
release the channel for itself. There are 5 voice priorities available, level 0 is
lower, level 3 is higher, and emergency call is the highest. To transmit the Priority
Interrupt command also can press the programmed [Priority Interrupt] key, in
order to make the channel free for new call or message transmission.
Via programmable software to set it: Channels folder→Zone→a digital channel
or A/D Channel→Priority Interrupt→Voice Priority
Note: This function is available only in digital operation.
Time Out Timer (TOT)
The purpose of TOT is to prevent any user occupy a channel for an extended
period. If a channel is busy, the time will be shorter. If the preset time expires, the
radio will generate beep and terminate transmission automatically. Via
programming software, you can set TOT as 15-495 second.
20
