Belden Hirschmann MACH104-16TX-PoEP Series, Руководство пользователя

Страница: 20 / 48

20
Installation MACH104-PoEP
Release 06 11/2013
The following table applies to all device variants:
If the manual adjustment is active on the “FAULT” signal contact, then the
detected error display is independent of the setting of the signal contact.
1.7.2 Port state
These LEDs display port-related information.
The LEDs are directly located on the ports.
The following table applies to ports 5 to 20:
LED Display Color Activity Meaning
Sb Stand-by None Stand-by mode not enabled
Green Lights up Standby mode enabled
FAULT Signal
contact
None The signal contact is closed - it is not
reporting any detected errors.
Red Lights up The signal contact is open - it is reporting a
detected error.
RM Ring
Manager None The RM function is deactivated.
Green Lights up The RM function is active.
The redundant port is disabled.
flashing The device detects an incorrect
configuration of the HIPER-Ring (e.g. the
ring is not connected to the ring port).
Yellow Lights up The RM function is active.
The redundant port is enabled.
RM
and
Sb ACA
memory
operation Flashing
alternately Error in the memory operation
flash
synchronously
– 2 x per period Save a configuration file from the ACA to the
device.
flash
synchronously
– 1 x per period Saving a configuration file from the device to
the ACA.
LED Display Color Activity Meaning
left LED Link status None The device detects an invalid or
missing connection.
Green Lights up The device detects a valid
connection.
Flashes 1 time a period The port is switched to stand-by.
Flashes 3 times a period The port is disabled.
Yellow Flashing The device is sending and/or
receiving data.
right LED PoE None No PoE voltage at port.
orange Lights up No PoE voltage at port.
Flashes 1 time a period No PoE voltage at port because
power capacity is exhausted.
Flashes 3 times a period The PoE voltage is deactivated in
the management system.