74
Operation
KMX-3901-OUT Network Settings Panel
KMX-3901-OUT Network Settings Panel
KMX-3901-OUT output cards are shipped with default network settings, which you must
replace with values suitable for your network environment. You may need to consult your
network administrator to get the correct values. Enter the appropriate IP address, mask and
gateway information to configure a KMX-3901-OUT output card within your Ethernet
network.
Click
Apply
to set these values into the card, or
Cancel
to leave the original values
unchanged.
Notes
• These settings apply to the rear-panel Ethernet port of the
KMX-3901-
OUT
output cards;
not
to the Ethernet ports at the back of the Densité
controller card.
• On all
Grass Valley
multiviewers, the network adapters are set to auto-
negotiate. By default, the connection speed and duplex mode will be set
automatically based on the corresponding port settings on the switch.
• The position of the output card is not configurable; the information is
presented here for information only.
• Quad-head Kaleido-Modular-X systems, which include two output cards,
require three IP addresses: one for each output card, and a virtual IP
address for the system. A dual- or single-head system requires only one IP
address (the output card’s IP address automatically doubles as the system
IP address). Refer to the Kaleido-Modular-X Quick Start Guide for detailed
setup information.
