Belden grass valley ICONTROL IC-BASE-EDITION-ENT-V3, Быстрый старт

Страница: 9 / 23

7
iControl
Quick Start Guide
• Apply your changes and perform a readiness check
Configuring the Application Server’s Network Settings
To configure your Application Server’s network settings
1 Configure a client PC or laptop to access the application server in its default
configuration (see Configuring TCP/IP Settings on a Client PC , on page 9).
2 Using a crossover Ethernet cable, connect your client PC or laptop to the eth0 port, on
the Application Server.
3 Open iControl admin on your client PC or laptop (see Opening iControl admin , on
page 8).
4 In the iControl admin page, under System settings , click Network interfaces .
The Network interfaces page appears.
5 Under System , perform the following:
a Type the host name by which you would like this Application Server to be known
on your network.
b If required, add DNS servers to the list of IP addresses in the DNS Servers list.
6 Under Eth0 , configure Ethernet interface settings:
a Select the Activate at boot-time check box.
b Type the IP address you would like to use for this Application Server.
c Type the appropriate network mask.
d Type the desired gateway address, if required.
Note: If you do not select the Activate at boot-time check box, the eth0
interface will revert to its previous values the next time the system restarts.
Note: Typically the IP addresses for all devices on a LAN begin with the
same two data groups, and the remaining two are assigned by the system
administrator.
eth0