EN
8
Removing packaging
reinforcement
Tilt the machine to remove the packaging
reinforcement. Remove the packaging
reinforcement by pulling the ribbon.
Opening the transportation
locks
C
Transportation safety bolts must be
removed before operating the washing
machine! Otherwise, the machine will
be damaged!
1. Loosen all the bolts with a spanner
until they rotate freely (“C”)
2. Remove transportation safety bolts by
turning them gently.
3. Fit the covers (supplied in the bag with
the Operation Manual) into the holes
on the rear panel. (“P”)
C
Keep the transportation safety bolts
in a safe place to reuse when the
washing machine needs to be moved
again in the future.
C
Never move the appliance without the
transportation safety bolts properly
fixed in place!
Appropriate installation location
Install the appliance in environments which
have no risk of freezing, in a stable and
level position.
C
The floor must be capable of carrying
the load on it!
C
If the washing machine and a drier
are placed on top of each other, their
approximate weight together may
reach 180 kg when they are full.
Important:
• Do not place the appliance on top of
the power cable.
• Keep at least 1cm distance from the
edges of other furniture.
• Place the machine on a firm surface;
do not position it on a long pile rug or
such like surfaces.
Adjusting the feet
C
Do not use any tools to loosen the
lock nuts. Otherwise, they can be
damaged.
1. Manually (by hand) loosen the lock
nuts on the feet.
2. Adjust them until the machine stands
level and firm.
3. Important: Tighten all lock nuts up
again.
Connecting to the water supply.
Important:
• The water supply pressure required
to run the machine must be 1-10 bar
(0,1 – 1,0 MPa). Attach a pressure-
reducing valve if the water pressure is
higher.
3
Installation
