Beko METPOINT UD01, Инструкция по установке и эксплуатации

Страница: 10 / 24

Installation and operating manual
EN
10 METPOINT
®
UD01
2.7. Control and display elements
The measured value is displayed on a 4-digit, 7-segment display panel that is also used to configure the device.
MPa
mbar
°Ctd °C
bar PSI Pa
°Ftd °F
hPa
Area for unit label
4-digit 7-segment display
Miniature push buttons
2.8. Menu control
The device menu is operated through the miniature push buttons. All settings are stored in EEPROM and thus
remain available even after a power failure.
• Menu >>▲<< UP
• Increase displayed value
• Menu >>▼<< DOWN
• Reduce displayed value
The stepping speed for the adjustment of the displayed value can be increased by pressing and holding the
respective push button for minimum 5 seconds.
+
• Confirm set value
• Change between configuration and display mode
• Open selected value
After adjusting the parameter value, confirm the entry and exit the respective menu. The new parameter value is
now applied.