18 / EN
Washer-Dryer / User’s Manual
3
Installation
To make the product ready for use, review the information in the user manual and
make sure that the electricity, tap water supply and water drainage systems are
appropriate. If they are not, call a qualified technician and plumber to have any
necessary arrangements carried out.
B
DANGER!
Make sure that the installation and electrical
connections of the product are performed by
competent persons. Manufacturer shall not be held
liable for damages that may arise from procedures
carried out by unauthorised persons.
DANGER!
Your product is too heavy for one person to carry.
A
CAUTION
• Prior to installation, visually check if the product
has any defects on it. If so, do not have it installed.
Damaged products cause risks for your safety.
A
PRECAUTION
• Preparation of the location and electrical, tap water and
waste water installations at the place of installation is
under customer's responsibility.
• Make sure that the water inlet and discharge hoses as
well as the power cable are not folded, pinched or crushed
while pushing the product into its place after installation
or cleaning procedures.
3.1 Appropriate installation location
• Place the product on a solid and level floor. Do not place it onto a carpet with high
pile or other similar surfaces.
• Do not place the product close to the edge if the floor contains steps. Do not also
place the product on a platform.
• Do not place the product on the power cable.
• Do not install the product in environments where the temperature falls below 0
ºC.(See. Warnings for Drying)
• Leaving a gap at the sides of the machine is suggested to reduce vibration and
noise