Beko BEHPH 090, Руководство пользователя

Страница: 191 / 228

19 / 56 EN
Remote Control / User Manual
7.10 Set function
or
SET
SET
OK
•
Press the SET button to enter the function
setting, then press SET button or TEMP or
TEMP button to select the desired function.
The selected symbol will flash on the display
area, press the OK button to confirm.
• To cancel the selected function, just perform the
same procedures as above.
• Press the SET button to scroll through operation
functions as follows:
ZoneFollow ( )

AP mode ( )
7.11 ZoneFollow function ( )
The ZoneFollow function enables the remote
control to measure the temperature at its current
location and send this signal to the air conditioner
every 3 minutes interval.
When using AUTO, COOL or HEAT modes,
measuring ambient temperature from the remote
control (instead of from the indoor unit itself)
will enable the air conditioner to optimize the
temperature around you and ensure maximum
comfort.
C
Press and hold turbo button for
Seven seconds to start/stop
memory feature of ZoneFollow
function.
•
If the memory feature is activated,
‘‘ON’’ displays for 3 seconds on
the screen.
• If the memory feature is stopped,
‘‘OFF’’ displays for 3 seconds on
the screen.
• While the memory feature is
activated, press the ON/OFF
button, shift the mode or power
failure will not cancel the
ZoneFollow function.
7.12 AP function ( )
(some units)
Choose AP mode to do wireless network
configuration. For some units, it doesn’t work by
pressing the SET button. To enter the AP mode,
continuously press the LED button seven times in
10 seconds.
7 How to use advanced functions