BEKA ZEPTO, Оригинальное руководство по эксплуатации и сборке, Страница: 49 / 56

-49- © BEKA 2019 All rights reserved!
BA
L_
ZE
PT
O_1
01
9D
E_
EN.docx
Level prewarning
(permanent display)
o
The inserted cartridge becomes empty
► Insert new cartridge and reset level prewarning (see
chapter
11.5 “ Level prewarning ” )
Motor error
o
The motor or the control in the device is defective
► Renew device
Overvoltage error
o
The supplied operating voltage is too high (> 30 V)
► Lower operating voltage
Undervoltage error
o
The supplied operating voltage is too low (< 9 V)
► Raise operating voltage
Temperature error
o
The device is operated outside the indicated temperature
range
► Heat or cool the device
Overpressure error (program P2)
o
Program P2 is active and the device receives a signal
because no sensor is connected or the connected sensor
is defective
► Connect the sensor or check the connected sensor
and renew it if necessary
o
Program P2 is active and the device receives a signal
because the pressure in the system has exceeded 290 bar
and the pressure limiting valve has opened
► Check system for blockades and leakages and
eliminate them
Pulse error (program P3)
o
Program P3 is active, but the device receives no pulse
signal because no sensor is connected or the connected
sensor is defective
► Connect the sensor or check the connected sensor
and renew it if necessary
o
Program P3 is active, but the device receives no pulse
signal because there is a blockade in the lubrication
system
► Check system for blockades and leakages and
eliminate them