13
16
1
Cycle time (h)
Service
EA / PA Controller
Typ BEKA-troniX1
Lubrication time (min.)
8
0,5
8
0,5
Connection cable
0,6 m long
EDP-Nr.:
1000912998
red
marking
ring
16
1
Cyc
le tim
e (h
)
Ser
vice
EA
/ P
A
Co
ntrol
ler
Ty
p B
EK
A-tr
on
iX1
Lub
rica
tion
tim
e (m
in.)
8
0,5
8
0,5
Multi line pump OC-1 with integrated electronic control
device BEKA-troniX1 with grease level monitoring.
Connection at the control device:
The grease level monitoring can be installed at the control
device BEKA-troniX1 under every operational mode.
Technical data of capacitive proximity switch:
Operating voltage:
10 to 60 V DC
Switching type:
PNP-contact
Switching current max.:
250 mA
Protection class:
contact:
IP 67
Ambient temperature range:
-25°C to +70°C
Connection:
4-pole, M12x1 pluggable
Multi line pump OC-1
Grease level monitoring
The integrated electronic controller BEKA-troniX1
facilitates monitoring of the grease level in the storage tank.
For purpose a capacitive proximity switch has been built in
to the pump´s reservoir.
As long as there is enough grease available in the reservoir,
the proximity switch sends a signal to the controller. If the
grease level sinks below minimum the proximity switch
turns the signal off.
If the signal remain off for more than 10 sec. then the
controller switches the pump off, so that no air is pumped
into the system.
The red LED on the controller display, situated on the
pump´s motor housing or a built-in red signal lamp, if
available, starts to illuminate.
Once the grease has been refilled, the controller restarts
itself.
The g ease level controller can be
r
delivered already
connected to the controller
n this case, a connecting
. I
cable, length 0,6 m, with a right-angle plug M12x1 for
connection to the plug-and-socket connector and a right-
angle plug M12x1 for connection to the controller is
included in the scope of supplies. The grease level
monitoring system is activated.
The grease level monitoring can be retrofitted. It can be
connected to the control unit, if the pump has been ordered
with additional functions.
In this case, the function must be activated by means of the
software BEKA-DiSys. The function must not be activated if
no grease level monitoring is activated, as this would result
in a permanent error.
Retrofitting the grease level monitoring, the connection
cable must be ordered separately (see drawing on the right
side).
The connection of BEKA-troniX1 control unit is done via the
red ring marked plug connection at the motor’s lower
casing.
For this purposes, remove the contact plug’s cover.
Subject to alterations!
...een product van BEKA
