10
Integrated electronic controlling device BEKA-troniX1:
Multi line pump OC-1
Parameter adjusting of BEKA-troniX1
16
1
Cycle time (h)
Service
EA / PA Controller
Typ BEKA-troniX1
Lubrication time (min.)
8
0,5
8
0,5
Resolution indicator to adjust lubrication time
Resolution indicator to adjust cycle time
Connection for
system diagnosis
The cycle time or lubrication time and the number of
revolutions can be set by means of graduating switches in
the controller´s sight glass.
To adjust the time setting, remove the red frame on the
pump´s motor housing
a flat screwdriver, loosen the
using
four Phillips screws and remove the transparent protective
cover.
The cycle during or lubrication time can be adjusted
a
using
flat screwdriver.
If the cover plate is not replaced properly, water may enter
the controller and damage it. In this case the guarantee is
,
no longer valid.
The modes and the adjusting ranges can be changed over
by means of the diagnostic software BEKA-DiSys, even on
site if the controller has already been operated before at the
customer´s.
All adjusting ranges for the lubrication period and all cycle
time ranges can be combined at random.
Adjusting the parameters:
Lubrication times:
1 to 16 min.
(16 notches every 1 min.)
2 to 32 min.
(16 notches every 2 min.)
2 to 32 sec.
(16 notches every 2 sec.)
Revolutions of pump:
1 to 16 revolutions
(16 notches every 1 revolution)
10 to 160 revolutions
(16 notches every 10 revolutions)
170 to 320 revolutions
(16 notches every 10 revolutions)
When changing the activation modes and the a justing
d
ranges, the label in the controller window must be
replaced.
To this effect, a label kit consisting of 18 different label
Model is available; these can also be ordered individually
afterwards.
Ref.-no. for label kit: 0490000342 German
Ref.-no. for label kit: 0490030343 English
Cycle
:
times
0 5 to 8 h
.
notches
.
(16
every 0 5 h)
2 to 32 min.
(16 notches every 2 min.)
2 to 32 h
(16 notches every 2 h)
Subject to alterations!
...een product van BEKA
