5
will be stopped,only the indication light shines, when the water temperature is below 40
℃
, it will
normally continue working.It is not allowed to work under the freezing environment.
4.Please don’t put it beside the TV or other electric equipment ,avoid from damaging them when
the mist maker produces misting
5.Suited Transformer/Adapter/Generator should keep away from the sprayer, and the sprayer water
can spill out and make it wet directly,due to the plug which is connected to the sprayer can’t be put
it into the water or wet.
6.In order to ensure the mist maker/sprayer/atomizer normally working under the nice
environment,please change the water every week,and use the clean soft cloth or rag to clean the
ceramic and water level sensor,but don’t use the chemical agent to clean,even also can’t use hard
or edge tool.
7.When the mist maker works,don’t put your hand above the sprayer,or else it will make you smart
feeling.
8.Although the adapter(transformer) for mist maker is used in outdoor ,but it can’t allow to be put
into the water.
五
:
Replace Method of Disc Piezoelectric Ceramic
after the mist maker is used for a long time,its misting rate will be reducing,you can replace the
ceramic disc to make it normally working at this time.
Methods as follows:
1.Use the ceramic disc key to wring out the copper ring with anticlockwise direction,and take it
out,please see clearly the ceramic disc face and bottom side.
2.Put the new ceramic disc on the original place(Please take attention to the installation direction
accorded with the same as original one.)
3.Put the copper ring,and use the ceramic disc key to screw down with the clockwise direction.
4.Please put the mist maker in the water container again,it can normally work as before.