GB
Sound module USM-RC-3
76
BEIER-Electronic
11.10.2021
Configuration - Nautic/Multiswitch
If you want to use the nautic mode 1 or 2, you will first have to activate it here and
connect the USM-RC-3 prop. channel #3 (X2/3) or #4(X2/4) to the receiver channel.
Switch assignment
Every switch position can be assigned to a function (see page 36).
Depending on the function, a memory setting for the corresponding switch can be
activated.
Type
Select the type of your radio control system and your nautic switch module here.
Error correction
If problems occur in receiving the nautic signal, you can activate error correction, as
this may lead to a more reliable transmission of the nautic switch data. However,
activating error correction slows down the transmission slightly (approx. +200 ms).
Especially with some 2.4 GHz transmitters it is advisable to switch error correction
on, as under certain circumstances incorrect switch positions are occasionally
transmitted, and this could trigger undesired actions.
Manual settings
Opting for manual settings enables you to set values for the transmission protocol of
the nautic mode manually. These values should only be altered as instructed.
Normally it is not necessary to set the values manually.
