BEFCO D90-060, Руководство оператора

Страница: 15 / 60

CAUTION: Never attempt to attach the shredder to the tractor or make any
adjustments to it without first turning the tractor off.
DANGER: Failure to ensure a secure coupling of the implement to the tractor can
cause injury and damage to the implement or tractor.
If necessary, wheel weights,
front tractor weights and/or tire ballast should be used to improve stability. Be
sure that the tractor tire pressure is correct. It is important to strictly follow the
safety guidelines and instructions laid out in the tractor operator’s manual.
To attach the shredder to the tractor do the following:
1. Back the tractor up to the shredder in order to slip the tractor hitch arms over the
hitch pins on the shredder hitch arms. Turn off the tractor engine. Secure them in
place with the lynch pins.
2. Adjust the tractor sway blocks or chains to remove all side movement.
3. Attach the top link. Adjust tractor top link to allow the shredder, in the working
position, to remain as level as possible with respect to the ground.
4. Install the shielded driveline to the tractor by first lining up the splines and
depressing the snap pin. Push the yoke onto the PTO shaft as far as it will go.
Release the pin and pull back slowly until the pin clicks in place. Repeat this
operation on the implement end. Be sure to install the overrunning clutch side of the
PTO shaft on the implement.
5. Attach the driveline chains to the tractor and to the shredder to keep the driveline
protection from turning. The chains should not be too tight.
6. Ensure the driveline has at least 2” from bottoming out in its shortest working
position and has the minimum 6” overlap in its longest working position. Refer to
Section 4.08
6
of this manual, if it is determined that the driveline is too long and
needs to be shortened. Contact your Authorized Company Dealer if it is determined
that the driveline is too short for your tractor.
3.06 - Start Up
DANGER: The shredder must always be lowered to the ground before starting
tractor engine or engaging PTO lever.
Lower shredder to the ground with the tractor rock shaft control lever until the roller is on
the ground and the shredder frame is parallel to the ground. Lock the tractor rock shaft
O
PERATION
15
BEFCO
D
ESTROYER
D90 O
PERATOR
’
S
M
ANUAL
6
See Section 4.08 - Driveline, for instructions on how to determine correct driveline length and
procedures for shortening the driveline.