the left square tube of the input shaft support. Place a cable tie around the hydraulic
cross and light wiring harness but do not tighten at this time
(see fig. 5)
.
7. Route the right and left light wiring harness alongside the hydraulic hose that
attaches to the rear cylinder (this hose is normally routed under the shaft protection
shields and located on the left side of the mower frame). At the rear of the mower
frame split off the right and left wiring. Route wiring along frame and plug wiring
harness into light plugs
(see #8, fig. 4)
. Place cable ties as shown in the illustration
(see fig. 5)
but do not tighten. Note: Because the rear wheel supports can be
adjusted in and out, be sure to leave extra wire to the light assemblies.
8. Wiring harness and hydraulic hoses should be clear of any moving parts. Once
wiring harness is in place, tighten cable ties and cut off excess. Plug in light
connector to the tractor to check light operation.
9. Replace all shields before operating the mower.
3.04 - Cutting Height Adjustment
WARNING: Keep hands and feet away from moving blades.
Be sure the tractor engine is off, parking brake is locked, and key is removed
before making any adjustments.
Never rely on the hydraulic system to hold the weight of the raised mowers.
Never walk or work under the raised mowers without first making sure the
automatic locking system is securely holding the wing units with the hydraulic
cylinders closed, and the hook is engaged to support the rear deck.
O
PERATION
17
BEFCO
C
YCLONE
S
UPER
-F
LEX
O
PERATOR
’
S
M
ANUAL
Fig. 6
The cutting height is
adjusted by moving
the height adjustment
spacers on the wheel
yokes above or below
the wheel arm.
