3.03 - Light Kit Installation
The light kit is an optional kit that can be purchased that contains two light assemblies,
two mounting brackets and wiring harness.
To install the light kit do the following:
1. Remove light assemblies, light mounting brackets, wiring and cable loom from
packaging.
2. Support the rear frame on the side that you are working on. Loosen but do not
remove the bottom set of nuts on rear wheel support. Remove the top nuts leaving
bolts in place
(see #4, fig. 4)
. Slide rear wheel support into operating position. Slide
the light bracket
(see #7, fig. 4)
over the top rear wheel bolts, replace nuts and
tighten. Note that there is a right and a left bracket.
3. Attach the light assembly to the light bracket using M6x25 hex head bolts and M6
elastic stop nuts supplied in the kit
(see #5 & 6, fig. 4)
. The light wiring harness is
routed through the slot at the end of the light assembly. Repeat steps 2 and 3 for the
opposite side of the mower. Note: The amber lens
(see #3, fig. 4)
are always to the
outside of the mower frame and the red lens
(see #2, fig. 4)
to the inside (facing the
rear of the mower frame).
4. Remove from the mower frame the front input shaft protection, the center shaft
protection and the rear shaft protection. Lay wiring harness on a flat surface. Notice
that the wiring harness splits off into a right and a left section. These wires are
labeled respectively “R” and “L”. Cut the smaller 3/8” wire loom in half. Working from
the light connector, insert the left wiring into one piece of wire loom and the right
wiring into the other
(see fig. 5)
.
O
PERATION
15
BEFCO
C
YCLONE
S
UPER
-F
LEX
O
PERATOR
’
S
M
ANUAL
Fig. 4 - Light brackets assembly (left rear view).
1
2
3
1. rear wheel support
2. red light
3. amber light
4
5
6
4. nut PT M14
5. bolt HH M6x25
6. nut ES M6
7
7. left light bracket
8
8. light connector
