Beem 02688, Руководство пользователя

Страница: 25 / 72

25 EN
5. Press the
MAHLWERK AUS
(grinder off) button (
18
). The control lamp in the
MAHL-
WERK AUS
(grinder off) button lights up. The grinder shaft is not opened when the brewing
process starts.
6. Press the
ON / OFF
button (
19
) to start the brewing process. The operating lamp in the
ON / OFF button and the control lamp in the dial fl ash. Hot water is poured over the
coffee to brew it.
To end the brewing process prematurely, press the
ON / OFF
button. The operating lamp
in the ON / OFF button is lit constantly, the control lamp in the dial goes out and the
device is switched off.
At the end of the brewing process, you will hear a beep, the operating lamp in the
ON / OFF
but-
ton goes out, the control lamp in the dial is lit constantly and the device automatically switch-
es on the hotplate (
14
) (see the “Handling and Operation” chapter – “Keep-Warm Function”).
Cleaning and Care
PLEASE NOTE!
• Do not use any toxic, corrosive or abrasive cleaning agents or scouring sponges to
clean the device. These may damage the surface.
1. Clean the fi lter insert, its lid and the glass jug (
13
) after each use with mild detergent and
warm water or in the dishwasher.
2. If necessary, wipe the coffee bean compartment ( 2 ) and the lid ( 1 ) with a damp cloth.
3. Wipe the housing with a damp cloth. If necessary, use a little mild detergent to remove more
intense soiling.
4. Check the connecting cable regularly for any damage.
Cleaning the Grinder Shaft
1. Take the coffee beans out of the coffee bean compartment (
2
) (Apart from the few beans
that you cannot reach by hand.)
2. Open the fi lter compartment ( 12 ) .
3. Insert a fi lter (see the “Handling and Operation” chapter – “Inserting the Filter”).
4. Close the fi lter compartment.
5. Press the
ON / OFF
button (
19
) to switch on the grinder. The operating lamp in the
ON / OFF
button and the control lamp in the dial fl ash.
6. Once the rest of the coffee beans have been ground – you can tell this from the change in the
grinding noise – stop the grinding process by pressing the ON / OFF button again.
7. Open the fi lter compartment and dispose of the fi lter. The rest of the beans remaining in the
grinder shaft should now also be removed.