Beef Eater 7000 Series, Руководство по сборке и эксплуатации, Страница: 73 / 76

TROUBLESHOOTING
PROBLEM CAUSE CHECK
Barbecue will not light Ignition system not working Check to see visible spark at starter probe
- if no spark is present when control knob
is turned then the unit may need to
be serviced or replaced. Contact your
BeefEater dealer.
Check that there is a visible flame coming
from the pilot ignition tube.
Check that the pilot ignition tube is not
blocked by spider webs or insect nests.
Turning on gas control too quickly Allow at least 5 seconds for gas to flow
through burner before ignition.
No gas flow Check that valve on gas cylinder is turned
on.
Check that burner ports are free of
obstructions.
Check that all gas injectors are clean and
free of obstructions.
Burners not assembled correctly Check that burners are correctly positioned
in the barbecue frame.
Burner ports or throat blocked Check that the burner ports are not
blocked by spider webs or insect nests.
Clean out as required.
Barbecue lights but goes out
soon after starting Fuel supply turned off Turn on gas valve at cylinder.
Gas cylinder low or empty Replace cylinder and carry out a leak check.
Kink in gas hose Check that the gas line is not kinked or
twisted.
Wind or breeze affecting operation Ensure that the appliance is located out of
the way of wind.
Burners will not cross light from one
to the other Check that cross light channel is in place.
Check that burner ports are free of
obstructions.
Low flame level or low heat output Burners will not cross light Check you are running on correct gas
Check gas injector size is correct.
LPG BTU/hr MJ/hr kW g/hr
4 Burners 64,451 68 18.89 1,371
5 Burners 80,564 85 23.62 17,714
NG BTU/hr MJ/hr kW
4 Burners 64,451 68 18.89
5 Burners 80,564 85 23.62
Gas Consumption
73
TROUBLESHOOTING