Beckman Coulter Allegra 21 Series, Инструкция по эксплуатации

Страница: 46 / 68

Operation
3-12
STOPPING A RUN
A timed run will end automatically when the TIME display counts down
to zero. To end a run in progress for any reason:
1. Press the [
STOP
] key for normal deceleration as selected by the decel-
eration curve.
(or)
Press the [
FAST STOP
] key for deceleration at the maximum rate (see
Table 3-1).
➠
NOTE
If you press [
FAST STOP
] the deceleration process
cannot be interrupted; the centrifuge can be restarted
only after the rotor comes to a complete stop and the
door is opened and closed.
2. After the rotor stops spinning and the [
OPEN DOOR
] light comes on,
press the [
OPEN DOOR
] key to release the door latches, then open
the door.
➠
NOTE
To prevent chamber icing, use a sponge to wipe
condensation out of the chamber bowl between runs.
UNLOADING
➠
NOTE
When you remove the rotor, make sure that the
tapered sleeve from the centrifuge drive shaft
does not come out with the rotor. If the tapered
sleeve is inside the rotor drive hole, remove it and
put it back on the drive shaft (see Figure 3-1).
After completing a run, unload the rotor following the instructions in the
applicable rotor manual.