Beckhoff CP6606, Руководство пользователя

Страница: 27 / 40

Decommissioning
CP6606 27 Version: 2.0
5 Decommissioning
NOTE
Hardware damage due to power supply
A connected power supply can cause damage to the Panel PC during disassembly.
• Disconnect the power supply from the device before starting to disassemble it.
As part of the decommissioning of the Panel PC, you must first disconnect the power supply and cables. You
can then remove the device from the control cabinet front.
If you do not wish to use the Panel PC any further, chapter 5.2 Disassembly and disposal [ } 28] provides
information on the correct disposal of the device.
5.1 Disconnecting the power supply and cables
CAUTION
Risk of electric shock
Disconnecting the Panel PC during a thunderstorm can lead to electric shock.
• Never disconnect the cables from the device during thunderstorms.
Before you remove the Panel PC from the control cabinet, you must follow the following steps:
1. Shut down the operating system.
2. Disconnect the Panel PC from the power supply (see below).
3. Disconnect the data transfer cables between the Panel PC and the connected devices (see below).
Disconnecting the power supply
Proceed as follows to disconnect the power supply:
1. Disconnect the PC from your external 24 V power supply.
2. Unscrew the 5-pin voltage connector and pull it out of the PC.
3. Remove the power cable if the 5-pin plug is to remain with the PC.
Disconnecting cables
Proceed as follows to disconnect the cables from the Panel PC:
1. Make a note of the wiring configuration, if you wish to restore it with another device.
2. Disconnect all data transfer cables from the Panel PC.
3. Finally, disconnect the ground connection.