Beckhoff CP6606, Руководство пользователя

Страница: 20 / 40

Commissioning
CP6606 20 Version: 2.0
4.2.3 Wall installation with wall mounting frame
NOTE
Reduced operating temperature range
Installing the CP6606 in the wall mounting frame reduces the operating temperature range to a maximum of
45 °C.
• Ensure that the maximum operating temperature range of the Panel PC is not exceeded.
As an alternative to installation in the front of a control cabinet, you can install the Panel PC in a wall recess.
For this you need a wall mounting frame. Use the following Beckhoff option:
• C9900-M317: wall mounting frame for building installation for 7-inch "Economy" built-in Panel PC
CP6606
Observe the following aspects when installing in the wall:
• The required wall cutout is 198 x 202 mm (W x H).
• Observe the correct installation position (top/bottom) of the wall mounting frame. The cable chamber is
located underneath the device (see Fig. ?).
• The installation frame must not protrude beyond the wall plaster and must be no more than 5 mm
deeper.
• You must mount the mounting frame horizontally. You cannot subsequently align the Panel PC in the
mounting frame.
• The maximum projection of the screw heads on the inside of the mounting frame must not exceed
2.5 mm.
To install the Panel PC in a wall using the wall mounting frame, follow the steps below shown in Figure 12:
1. Screw the enclosed latching elements of the ball catch onto the back of the Panel PC using the M3x6
screws (section A).
2. Install the wall mounting frame flush in the intended wall (section B).
3. If necessary, adjust the position of the mounting frame in the wall using the ball catches.
4. Screw the wall mounting frame into the wall using the four ST 3.5 x 25 screws (section C).
5. Snap the Panel PC into the ball catches of the wall mounting frame.
6. Plaster the lower part of the wall mounting frame flush with the surface (section D).
ð You have installed the Panel PC in a wall.