®
BCR130/5-BCR164/6,5-BCR300/12
BEAST CORE RIG OPERATING MANUAL
7
4) Power tool use and care
a) Do not force the power tool. Use the correct
power tool for your application. The correct
power tool will do the job better and safer
at the rate for which it was designed.
b) Do not use the power tool if the switch does
not turn it on and off. Any power tool that
cannot be controlled with the switch is dan-
gerous and must be repaired.
c) Disconnect the plug from the power source
and/or the battery pack from the power tool
before making any adjustments, changing
accessories, or storing power tools. Such
preventive safety measures reduce the risk
of starting the power tool accidentally.
d) Store idle power tools out of the reach of
children and do not allow persons unfamil-
iar with the power tool or these instructions
to operate the power tool. Power tools are
dangerous in the hands of untrained users.
e) Maintain power tools. Check for misalign-
ment or binding of moving parts, breakage
of parts and any other condition that may
affect the power tool’s operation. If dam-
aged, have the power tool repaired before
use. Many accidents are caused by poorly
maintained power tools.
f ) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to
control.
g) Use the power tool, accessories and tool bits
etc. in accordance with these instructions,
taking into account the working conditions
and the work to be performed. Use of the
power tool for operations different from
those intended could result in a hazardous
situation.
5) Service
a) Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts. This will ensure that the safety of
the power tool is maintained.
FOR YOUR SAFETY
Working safely with this machine
is possible only when the operat-
ing and safety information are
read completely and the instruc-
tions contained therein are
strictly followed. Before using for
the first time, ask for a practical
demonstration.
Before working on the machine itself,
pull the mains plug.
Be careful of hidden electrical lines or
gas and water pipes. Check the work-
ing area, e. g., with a metal detector.
Wear safety goggles and
hearing protection.
•
Before commencing work, the GFCI protec-
tive switch must be checked for proper
functioning.
•
Before commencing work consult the
responsible structural engineers, architects
or site supervision about any planned bor-
ings, especially when cutting through rein-
forcing steel.
•
The machine may only be operated using
a power supply with protection earthing
according to the regulations.
•
The machine may not be operated by per-
sons under the age of 16 years.
•
The drill stand must always be mounted
firmly and must not be able to move during
drilling.
•
Only mount the drill stand on an even, firm
and smooth surface using the vacuum
pump.
•
When carrying out “over” head wet cut core
drilling, a water collecting ring and water
suction are always to be used. These must
be in perfect condition.
•
When drilling “over” head
always
secure the
drill stand with the assembly.
•
Prevent the drilling core from falling.
