®
BCR130/5-BCR164/6,5-BCR300/12
BEAST CORE RIG OPERATING MANUAL
11
Hand held dry drilling
Mounting the dry drilling kit 10
A
B
•
Loosen the frontgrip
5
of the core drilling
machine.
•
Mount part A of the dry drilling kit onto the
drill spindle
6
.
•
Slide the dry drilling sleeve (B) on part A in
the desired position for the vacuum cleaner.
•
Tighten the grip
5
.
•
Mount the hose of a industrial vacuum
cleaner on the sleeve (B).
•
Mount a core drill
31
onto the drill spindle
6
.
Using the dry drilling kit 10
•
Drilling is only possible if the masonry is
absolutley dry. Use a powerful industrial dust
exhauster. Change the filter regularly, there is
risk of obstruction.
•
Hold the machine as rigidly as possible.
•
Always use the grip
5
at the front of the
machine.
•
Start drilling by keeping the machine at a
slight angle.
•
After the bit is guiding itself into the material,
swivel back the machine into the right angle
position.
WARNING: The machine has a very
high torque, especially in the first
gear. Therefor drill only extremely
concentrated, especially when
working in first gear and with
diameters of more than 60 mm. In
case of sudden blocking of the core
bit the machine, despite the safety
clutch, might get out of control and
hurt you considerably.
DRILLING WITH A DRILL STAND
Guide block setting
A
B
When using a drill stand a right setting of the
guide block is required. Guide blocks for BCR core
drilling machines features slide strips for fine tun-
ing on the drill stand.
•
Loosen the safety nuts (A) using the supplied
wrench 13.
•
Adjust the bolts (B) for an flexible sliding of
the guide block on the drill stand.
•
Secure then the bolts with the safety nuts (A).
Using Quick Release Guide BCR300/12
You can easy release the core drilling machine
BCR300/12 from its Quick Release Guide and so
from the drill stand.
•
Loosen the guide block safety bolt
36
with
the feed lever
13
.
•
Pull the machine safety lock.
•
Slide the core drilling machine gently from
the guide block.
•
When replacing the machine secure accord-
ingly.
Aligning the drill stand
•
Set up the drill stand at the drilling location.
•
Pull the safety bolt
22
and rotate the center-
ing plate
23
forwards, until it snaps in.
•
Align the drill stand in such a manner that
for the used machine the tip of the centering
