IntelliDOCK 9555 Installation & User Manual
17
Unpacking and Testing
1. Unpack all components and assemble them on a service bench.
2. Position the antenna several meters from the other components to
avoid potential interference.
3. Following the next steps, use the AC power adaptor or a bench
power supply in place of the vehicle battery, verify that all
components are functioning properly.
Connecting Power to the Interface unit
The IntelliDOCK power cable has a 4-way connector, which provides
+VIN
,
GND
(0V), and
ACC
(On/Off control).
The IntelliDOCK can be powered from either the AC/DC power adaptor,
or the DC cable lead, (which are both supplied in the kit).
A: Powering from the “AC/DC power adaptor”
The AC/DC power adaptor supports international AC voltage ranges for
global compatibility.
1. Please ensure that the Power Adaptor cabling has enough length
to reach the IntelliDOCK cradle, and that it is plugged into a power
outlet of suitable safe power capability. If using a power-board
extension, ensure that it is not overloaded.
2. DO NOT apply power to the outlet until full installation is complete.
3. Connect the 4-pin output connector to the IntelliDOCK cable loom.
WARNING:
Do not connect the terminal to the Battery Supply until the installa-
tion is complete.
DO NOT
replace any fuse with a higher amperage fuse.
CAUTION:
Failure to follow these steps may cause the accessory not to work
properly and may cause damage to the phone.
