200646_01
9
9.
FITTING THE BURNER UNIT
1
Check that the ignition system functions correctly. Push in the control valve and operate
the piezo ignition mechanism and check that a spark is generated at the pilot burner. If no
spark is evident, check the connections and the soundness of the leads.
2
Check tightness of nuts at the control-valve end of the thermocouple. CAUTION: Do not
over-tighten.
3
Plug the connector on the solenoids on the underside of the burner unit to the mating plug
on the switch panel of the fire. (See Figure 9)
4
Place the burner tray in position within the firebox. The tabs on either side of the rear of
the burner should be pushed on to the brackets on the firebox and then the burner fixed in
place using the screw in the centre of the fascia panel.
5
Connect the gas supply pipe to the fire using the nut and olive provided. Ensure that the
gas line is purged before connecting the pipe, as any debris left in the pipe will cause the
appliance to malfunction if it enters the controls.
10
ELECTRICAL CONNECTION TO MAINS SUPPLY
FIGURE 8
FIGURE 9