Seite
19
von
27
2. COMMISSIONING
•
Fill the water tank as follows:
1. Remove the top cover of the humidifier.
2. You can now lift the water tank out of the base by
lifting it by the handle.
3. Turn it upside down and open it by turning the water
tank lid counterclockwise.
4. Then fill the water tank with water, being careful not to
overfill it.
5. Close the water tank again by tightening the tank cap
clockwise.
6. Now dry the outside of the water tank and put it back into the base.
7. Finally, replace the top cover and turn the mist nozzles to any position.
IMPORTANT
Please note the following when filling the water tank:
• Do not use any essential oils in the water tank (e.g .: eucalyptus or menthol)
as these could damage the device.
• Do not put metals, chemicals or detergents in the water tank.
• Never fill the water tank completely.
• Never fill the water tank with water with a temperature over 40 ° C to avoid
deformation.
• Fill water only into the water tank and never into the other parts of the
humidifier.
• Never fill the water through the steam outlet.
• If the room temperature is less than 0 ° C, empty the water tank as freezing
water could damage the humidifier.
• If there is a lot of water in the water tank, do not move the humidifier
excessively, otherwise water could leak out and penetrate other parts of the
humidifier and cause irreparable damage.
• Discoloration of the device is normal due to the evaporating water.
•
Use of aromatic oill:
1. ou can use aromatic oil to give the escaping
steam a pleasant scent.
2. Push the aroma oil compartment on the back of
the device to pull it out.
3. Then dribble a little oil into the sponge provided
and put the aroma oil compartment back in.
4. As soon as you switch on the device, the aroma diffuser function is
activated automatically.
5. You can wash the aroma oil sponge and use it again as soon as it is dry.
