BE Ag & Industrial BE-RCR G Series, Руководство по эксплуатации и запасным частям

Страница: 9 / 16

BE-RCRxxxG USER MANUAL
9
MAINTENANCE
1. Periodically check and maintain proper gear oil level.
2. Approximately every 8 hours, grease spindles, roller axle, wheel forks, wheel axles, PTO shaft universal
joints, and PTO telescoping surface.
NOTE: Use a high-temp / multi-purpose grease.
3. Before each use check to make sure all safety features are installed and working properly.
4. Keep blades sharp and balanced at all times. When replacing the blades, replace all blades and blade
bolts and the same time.
5. Periodically check all nuts, bolts, and belt to insure they are tight and secure.
Arrows indicate grease points.
MAINTENANCE SAFETY
Good maintenance is your responsibility. Poor maintenance is an invitation on trouble.
Follow good shop practices.
Keep service area clean and dry.
Be sure electrical outlets and tools are properly grounded.
Use adequate light for the job at hand.
Make sure there is ample ventilation. Never operate the tractor engine in a closed building. The exhaust
fumes may cause asphyxiation.
Before working on this machine, disengage the PTO, be certain all moving parts on attachments have come
to a complete shop, shut off the engine, set the bakes, and remove the ignition keys before attempting to
perform maintenance.
Never work under equipment unless it is blocked securely.
Always use personal protection devices such as eye, hand and hearing protectors when performing any
service or maintenance.
Frequently tighten all bolts, nuts, screws and check that all cotter pins are properly installed to make certain
unit is safe to operate.
When completing maintenance or service, make sure all safety guards and devices are installed before using
the Rough Cutting Mower.
After servicing, be sure all tools, parts and service equipment are removed from the Rough Cutting Mower.
Do not allow debris, grease or oil to build up on any deck or platform.
Where replacement parts are necessary for periodic maintenance and servicing, factory replacement parts
must be used to restore your equipment to original specifications.
The manufacturer and/or distributor will not be responsible for injuries damages caused by use of
unapproved parts and/or accessories.
A first aid kit should be kept readily accessible while performing maintenance on this equipment.