BE Ag & Industrial BE-RCR G Series, Руководство по эксплуатации и запасным частям

Страница: 7 / 16

BE-RCRxxxG USER MANUAL
7
TRANSPORT SAFETY
Always observe state and local laws governing highway safety and the travel of farm machinery on public
roads.
The use of flashing amber lights is acceptable in most locations. However, some locations prohibit use. Local
laws should be checked for all lighting and marking requirements.
When driving the tractor and equipment on roads or highways use flashing amber warning lights and a slow-
moving vehicle (SMV) identification emblem. Do not exceed 20 mph. Reduce speed on rough roads and
surfaces.
Plan your route to avoid heavy traffic.
Always install transport locks, pins or brackets before transporting.
Do not drink and drive.
Be a safe and courteous driver. Always yield to oncoming traffic in all circumstances, including narrow
bridges, intersections, etc. Watch for traffic when crossing or operating in close proximity to roadways.
Turn curves and go up and down hills only at a low speed at a gradual steering angle. Make certain that a
least 20% of the tractor’s weight is on the front wheels to maintain safe control. Slow down on rough and/or
uneven surfaces. Always check tractor manual for proper use on slopes.
Use extreme care and maintain minimum ground speed when operating close to ditches and/or fences. Be
careful when turning sharp corners.
Never allow riders on either tractor or mower.
ATTACHING TO TRACTOR
WARNING
Never stand between tractor and Rough Cutting Mower while backing the tractor up to the hitch
STEP 1 Attach to tractor’s three point hitch as described in the Tractor’s Operator’s Manual.
STEP 2 Apply any multi-purpose grease to the outside of the male (inner) PTO shaft section. Assemble
PTO shaft and install on Rough Cutting Mower and tractor.
WARNING
Failure to install the retaining clip on gearbox input shaft would allow the driveline to swing freely if the
bolt is sheared causing possible injury or death.
STEP 3 Pull shaft on tractor side of PTO shaft yoke to be sure it has locked in place. Make certain PTO shaft
guards are in place and good working condition.
STEP 4 The PTO shaft guard is a non-rotating design and must be secured prior to equipment use.
OPERATING INSTRUCTIONS
This mower was designed to CUT PASTURE GRASS AND ROUGH AREAS UP TO 1” IN DIAMETER. Use of
your Rough Cutting Mower to cut any material larger than 1” in diameter may damage the mower and void
your warranty.
PRE-OPERATIONAL ADJUSTMENTS
Set tractor’s lift control stop at a position that will prevent the PTO shaft from coming in contact with the
front edge of the mower when it is at full lift. Consult your tractor manual for instructions.