BE-WCGF4xxx USER MANUAL
15
• Use common sense when using your chipper.
• Learn to recognize the change in the sound of your machine when it is overloaded.
• Become familiar with successful operating conditions and avoid those that can overload and damage the
machine.
• If the machine becomes jammed by overloading or any other cause, stop the machine immediately.
• If you jam the machine and do not stop the engine, it can:
• Burn the belt
• Ruin the clutch
• This damage can be costly and it may not be covered under warranty. For this reason, it is important that
you immediately shut off the machine if it becomes jammed.
• Only your operator experience will tell you how fast to feed limbs.
• Check to see that the flywheel will turn freely before you start the chipper.
• Visually check chipper knife for damage each time you use your chipper.
• Check knife condition, wear plate condition, gap setting and the nuts and bolts that hold the knife in place
for tightness every 8-10 hours of operation
• Do not allow chips to build up within 3” of discharge chute opening. Move chipper or pile as needed.
Failure to do this could result in unnecessary jamming of the machine
• To move pile of processed material, use spade, rake, or long handle tool. Never use your hands or feet!
To free a jammed flywheel
• Stop the engine.
• Remove the spark plug wire and keep away from the spark plug.
• Disconnect battery at negative terminal (if so equipped).
• Remove any material left in the chipper hopper.
• Remove the deflector.
NOTE: Never pry against the scroll weldment when removing the deflector or at any other time. This will
cause damage to the machine.
• Check to see if deflector is clogged. If it is, clear with a branch.
• With a wooden stick, loosen and remove any material left in the chipping chamber.
• Reinstall the deflector.
• Reconnect the spark plug wire and battery (if so equipped).
• Start machine and let material in chipping chamber discharge through deflector.
• If chamber doesn’t clear and the flywheel is still jammed, repeat above process.
• Be certain chipping chamber is clear before trying to process more material into the chipper.
Содержание AgriEase BE-WCGF4 Series
Страница 23: ...BE WCGF4xxx USER MANUAL 23...