12
BE-WCGF4xxx USER MANUAL
SECTION III - OPERATION
Before starting engine, always check oil level!
Refer to the engine owner’s manual for further details regarding operation and maintenance of the
engine.
NOTE: engine is shipped without oil! Fill crankcase with oil before starting engine. Be very careful not to
allow dirt to enter the engine when checking or adding oil or Fuel.
NOTE: if you start the engine without oil, the engine will be damaged beyond repair and will not be
covered under warranty.
Oil
• Use a high quality detergent oil classified “For Service SF, SG, SH, SJ” or higher.
• Do not use special additives.
• Choose a viscosity according to the following table.
CAUTION
Air cooled engines run hotter than automotive engines. The use of non-synthetic multi-viscosity oils
(5W-30, 10W-30, etc.) in temperatures above 40 deg. F (4 deg. C) will result in higher than normal oil
consumption. When using a multi-viscosity oil, check oil level more frequently.
CAUTION
SAE 30 oil, if used below 40 deg. F (4 deg. C), will result in hard starting and possible engine bore
damage due to inadequate lubrication.
CHECKING AND ADDING OIL
• Check oil level before starting the engine.
• Check level daily, or after every eight hours.
• Keep oil level at FULL.
• Do not overfill.
Oil filling procedure:
First add 1 quart. Start and run engine at idle for 30 seconds. Shut engine off and wait 30 seconds. Then add
more oil slowly to bring level to Full mark on dipstick.
Oil checking procedure:
Before starting engine, check oil level.
• Place engine level. Clean around oil fill and dipstick.
• Remove dipstick and wipe clean with cloth.
• Push dipstick back in and remove to check oil level.
• Remove oil fill cap. Pour oil slowly.
• Fill to Full line on dipstick – recheck.
• Replace dipstick firmly.
Содержание AgriEase BE-WCGF4 Series
Страница 23: ...BE WCGF4xxx USER MANUAL 23...