BDS MABasic 200, Перевод оригинальной инструкции по эксплуатации

Страница: 13 / 20

13 MABasic 200, 400, 450, 850
GB
Drilling with the machine
Drilling with core drills
When drilling with core drills, proceed as
follows:
‹
Insert the corresponding ejector
pin (22) into the core drill.
‹
Insert the drill chuck with the ejector
pin as described in chapter Inserting
the tool .
‹
Place the machine at the work loca-
tion, align it and switch on the magnet-
ic clamps.
‹
Switch the machine on.
‹
Direct the drill to the material with the
handle (6).
NOTE
Observe the following instructions when
drilling with core drills:
► Drilling with core drills does not re-
quire great force. The drilling process
is not accelerated by higher pressure.
The drill wears faster and the ma-
chine can be overloaded.
► Use the high-performance BDS 5000
cutting oil in the cooling lubricant
system of the machine.
► The cooling lubricant system cannot
be used when working overhead. In
this case, use the high-performance
ZHS 400 grease spray. Spray the drill
on the inside and outside before drill-
ing. In the case of larger drill depths,
repeat this procedure.
► Make sure that swarf is removed
regularly. With larger drilling depths,
break up the swarf.
Eliminating blockages
WARNING
Danger of cut injuries from broken
tool parts or swarf .
► Put protective gloves on before start-
ing work.
Blockages caused by a broken tool:
‹
Switch off the machine. Remove plug
from the mains socket.
‹
Use the handle to move the machine
slide to the upper position.
‹
Replace defective tool. Remove swarf.
Other blockages:
‹
Switch the machine off using the mo -
tor switch. Leave the magnetic clamp
switched on.
‹
Use the handle to move the machine
slide to the upper position.
‹
Remove swarf and check tool.
Eliminating blockages