BDS MAB 455, Оригинальная инструкция по эксплуатации

Страница: 14 / 22

14 MAB 455
GB
KEYLESS quick-change drill chuck
system (Fig . 2)
Inserting the tool
‹
Push the KEYLESS quick-change
drill chuck system (A) into the spindle
taper (3) of the machine.
‹
Connect the lubricant line.
‹
Open the quick-change drill chuck sys-
tem (A) by pushing up the sleeve and
insert the tool into the chuck.
NOTE
► Insert the appropriate ejector pin
before inserting the core drill.
► Turn the tool briefly to check whether
the collet is engaged.
Removing the tool
‹
Open the quick-change drill chuck sys-
tem (A) by pushing up the sleeve and
pull the tool down out of the chuck.
Using
Activating/deactivating the mag-
netic clamp
Activating the magnetic clamp
ATTENTION
► To prevent the magnet from overheat-
ing, switch on the magnetic clamp
only when the machine is standing on
a magnetic substrate.
‹
Switch the magnet (23) ON/OFF
switch on. The indicator lamp in the
magnet (23) ON/OFF switch on.
‹
Check the magnet holding force with
the magnet indicator („MAGNET
POWER“ (22) indicator light)).
MAGNET POWER
indicator light
Magnetic holding
force condition
GREEN Sufficient
magnetic holding
force
RED Insufficient magnet -
ic holding force
ATTENTION
► The maximum magnetic clamping
force is only available after switching
on the motor.
Deactivating the magnetic clamp
‹
Hold the handle tightly (9) to stop the
machine from slipping.
‹
Switch the magnet (23) ON/OFF
switch off. The indicator lamp in the
magnet (23) ON/OFF switch extin-
guishes.
Preparing, Using