October 2020 – issue 1
Page
11
of
29
Section 3 - Operating Guide (continued)
ZERO EMISSION CITY BUS Owner’s
Manual
3C1.1 - Ignition switch
(figure 5):
The photo on the right shows the Ignition key position.
“LOCK”
：
This is the place to insert and draw out key. Power off
“ACC”
：
Accessory power on, power on
“ON”
：
Instrument and Control power on
“START”
：
Puts the power train into ready to drive mode,
Hold the key in start position for approx. 3 seconds after the ‘READY’ message
Appears in the dash display screen.The vehicle is now ready to drive.
3C.2 – Wiper & direction indicator control stalk
(figure 6):
This is located on the left side of the steering column.
Figure 5
Figure 6
Horn switch: Push the button on the end of the indicator stalk to activate the horn, release to turn off.
To spray water on the screen, press the stalk inwards, the wipers will automatically start in the low speed and will
automatically turn off a few seconds after the button is released. Rotate the stalk to operate the wiper:
OFF: Stop wiping
: Intermittent wiping
I: Wiping at a low speed
II: Wiping at a high speed
This is the turn signal indicator sign. Move the lever upwards to engage right-turn signal; move the lever
downwards to engage left-turn signal.
This function is for turning on high beam by pulling stalk upwards, or intermittent high beam by briefly holding and
releasing the stalk.
Horn
