4
- Some countries do not allow the exclusion or limitation of
incidental or consequential damages or exclusions of
implied warranties. Therefore, the limitations or exclusions
herein may not apply. This warranty gives you specific legal
rights, in addition to other rights which vary from state to
state or country to country.
Make sure that the device is not plugged into the mains
before making any connections. It is also recommended to
turn off or disconnect all other devices associated while
making connections to the product.
Connect the speakers to the speaker jacks on the back and
the sources of the corresponding input jacks on the back.
Connect the power cord to the connector on the one hand
AC Mains product and the other to a wall outlet.
Turn
the
POWER
switch
(POWER)
ON
(ON).
*page 6, button
⑪
under the am.
If the unit is equipped with a standby, then press the
STANDBY button to turn it on.
Press the input selector for the source you want to hear.
Warning:
Be sure to turn off the power switch on your
product before making any connections. Similarly it is best
to cut the power of the other devices you want to connect
to your amplifier.
① & ⑨ LOUDSEPAKER TERMINALS
Connect the speaker to the terminals marked RIGHT "+ R"
and "R -" ensuring that "R +" is connected to the "+"
terminal of the enclosure and "R -" is connected to the
terminal "- "the same enclosure. Connect the LEFT speaker
to the terminals marked "L +" and "L -" by doing the same.
Make sure that no wires are not insulated can bypass the
speaker outputs. Make sure that the speaker terminals are
tight enough to ensure a good electrical connection. If the
terminal screws are not tight enough, the sound quality
may be affected.
Use only dedicated wire to the speaker (a section of 1.5
mm² or more is recommended especially if the cable length
is greater than 3m).
Important Note:
Check the impedance of your speakers.
When using a pair of speakers, you can use speakers with
an impedance of between 4 and 8 ohms.
② & ⑧ XLR CONNECTIONS
XLR connections (INPUTS
⑧
or OUTPUTS
②
) allow the use
of symmetric links. This type of cables guarantees greater
immunity to electromagnetic interference screw. Their use
is recommended in particular when the distance between
the devices is important.
Basic instructions
Quick starting guide
Warranty
Connection to the amplifier
Rear panel
Содержание EX362D
Страница 10: ...10 Notes...
Страница 11: ...11...
Страница 12: ...12 BC ACOUSTIQUE BP 306 94709 Maisons Alfort Cedex France www bc acoustique com...