GSS3219B
Owner’s Manual
8
Step 4 (Assemble the front beam to
the cart)
a) Place the front beam (E) on the
two cart side panels.
b) Align the two holes on the right
end of front beam (E) with the
top & side two holes on the
frame of cart right side panel.
c) Insert one M6 x 15mm bolt (BB)
with one M6 spring washer (FF)
and one M6 washer (EE) into
each pre-drilled hole. Tighten
bolts by hand until secured.
d) Repeat the procedure for the
frame of cart left side panel.
e) Go back and tighten all bolts
using the screwdriver provided.
Step 3 (The cart back panel
assembly)
a) Loosen the four pre-installed
bolts on the cart side panels
and allow 1/4 bolt’s length to
extend from the cart side
panels.
b) Align the four holes on the cart
back panel (D) with the four
bolts extended from the cart
right side panel and cart left
side panel.
c) Push down the cart back panel
(D) until it locks into place.
Tighten all bolts using the
screwdriver provided.
BB
M6X15 Bolt
4 PCS
FF
M6 Spring Washer
4 PCS
EE
M6 Flat Washer
4 PCS
