GSS3219B
Owner’s Manual
11
Step 10 (Assemble the side shelfs with the body assembly)
a) Loosen the four pre-installed bolts on the left side of body assembly and allow 1/4 bolt’s length to extend from body
assembly.
b) Align the holes on the left side shelf (H) with the bolts extended from the left side of body assembly.
c) Push down the left side shelf until it locks into place. Tighten bolts by hand until secured.
d) Pull out the drawer from the left side shelf, then align the hole on left side shelf with the hole on the front control panel.Insert
one bolt (BB) into the pre-drilled holes.
e) Align the hole on the cart left side panel with the hole on the left side shelf ,then insert one bolt (AA) with one flat washer (EE)
into the pre-drilled hole towards into body assembly.
f) Tighten bolts by hand until secured.
g) Repeat the above procedure for the assembly of right side shelf (K) and body assembly (L).
h) Go back and tighten all bolts using the screwdriver provided.
Step 9 (Assemble the body to the cart)
a) Place the body assembly (L) on the
top of cart assembly.
b) Align the two holes on the left top of
cart assembly with the two holes on
the left of body assembly (L).
c) Insert one M6 x 15mm bolt (BB) with
one M6 spring washer (FF) and one
M6 flat washer (EE) into each
pre-drilled hole.
d) Tighten bolts by hand until secured.
e) Repeat the procedure for the right
assembly.
f) Go back and tighten all bolts using
the screwdriver provided.
BB
M6X15 Bolt
4 PCS
FF
M6 Spring Washer
4 PCS
EE
M6 Flat Washer
4 PCS
AA
M6 X 33 Bolt 2
PCS
BB
M6X15 Bolt
2 PCS
EE
M6 Flat Washer 2
PCS
