Bayside Furnishings
®
Page 11 Factory No. 16366
20.
Position the Top Rail (B) onto the Side
Rails (C and D) to finish the assembly.
21.
Separate the arc cover from the Cable Channels (Q).
22.
Place the flat side of Cable Channel (Q) where the Cable Channel is to be installed on the wall. Using
the Cable Channel (Q) as a template, mark 4 mounting hole locations with a pencil. Using a 5/16”
masonry drill bit, drill the mounting holes at least 1-1/4" deep at the marked locations.
23.
Insert the Small Wall Anchors (10) into the drilled holes and lightly tap them flush with the concrete
surface with rubber mallet or hammer. Securely attach the Cable Channel (Q) over the Small Wall
Anchors (10) in the wall with four M4 x 20 mm Screws (12) and tighten with a Phillips screwdriver.
NOTE:
If installing the Cable Channels (Q) to a wooden stud wall, there is no need to drill the holes in
the wood and no need for the plastic wall anchors.
24.
Repeat the same process to install the other Cable Channel (Q). Now, route the cables along the Cable
Channels (Q), as shown. With all cables in place, snap the arc cover onto the Cable Channel (Q) to
provide a neat appearance. You can paint the channel to match the wall color, if desired.
A
B
10
12
1-1/4" (32 mm)
Q
Q
10
12
10
12
10
12
Q
Q
Installation – Wall Mount (continued)
