Installing the HRPSU
114312 Rev. C
2-13
Installing a Power Supply Module in the HRPSU Power Rack
The HRPSU power rack and the power supply modules are packaged separately.
You must install the power supply modules in the HRPSU power rack. You can fill
the slots in any order.
Figure 2-10
shows a power supply module being inserted
into the HRPSU power rack.
Figure 2-10.
Inserting Power Supply Module in HRPSU Power Rack
Install the power supply module using the following steps:
1.
From any slot, remove the blank front panel as follows: with your fingers
under the top edge of the panel, pull outward. Discard the panel.
2.
Lift the latch of the power supply module and slide the module straight
into the slot between the side rails. The flange on the back of the module
releases the safety door as the module pushes the door up.
When the module cannot go any farther, it is connected to the backplane.
3.
Push the latch down firmly to lock the module in place.
HRP0009A
Redunant
AC Power Module
Power OK
RUN
BOOT
POWER
Access Stack Node
