Installing the HRPSU
114312 Rev. C
2-9
Figure 2-6.
Locating the Rail Holes
3.
Insert each angle bracket inside the rack in the area indicated in
Figure 2-7
.
Using
Figure 2-7
as a guide, attach the angle brackets as follows:
a.
If there are no threads in the rail holes where you will attach the
angle brackets, insert four cagenuts over the holes.
b.
Align the edge of the bracket to the rack.
If the interior of the rack has horizontal bracket supports, align the angle
brackets with the supports. Otherwise, brace the angle brackets between
the side rails.
c.
Insert a 10-32 screw through the slots at each end of the bracket and
into the holes in the rack supports. Do not tighten the screws.
d.
Adjust each bracket vertically along the bracket slots until the
bracket is 0.78 in. (1.98 cm) below the center of one hole in the front
vertical support of the rack.
e.
Tighten the screws with a Phillips screwdriver.
Mounting hole locations
Angle bracket
supporting router
mounted on back of
rack post
Rack post
0.500"
0.625"
Flange
ASN0001A
