Installing and Maintaining the HRPSU
2-4
114312 Rev. C
You can install up to four adapters on the HRPSU; however, only one network
device may be attached to each adapter.
1.
Place the adapter over any 24-pin output connector on the HRPSU, as
shown in Figure 2-2, and firmly press the 16-pin adapter connector into
the HRPSU 24-pin connector.
2.
Insert and tighten the captive screw supplied for the adapter.
Note:
By default, the adapter for 16-pin cable connections is shipped with a
protective cover over the P2 connection. If your network device requires two
16-pin connections, you must remove this cover before attempting to attach
the second network device cable.
Note:
If there is an EMI gasket on the 24-pin connector, remove it first.
