Point-to-Point Protocol (PPP)
4-2
893-826-A
3.
Press the RETURN key.
When you supply the correct password, the following message appears:
Press <RETURN> to modify configuration, any other key to abort.
4.
Press the RETURN key when you see this prompt.
The server displays the following message:
Change leaves approximately
nnnnn bytes free.
TS3395>>
5.
Use the SHOW SERVER PARAMETER command to verify that all
parameter servers are “Current.”
6.
Then reinitialize the unit, so that the change takes effect.
You can use the command:
TS3395>> initialize delay 0
Configuring a PPP Port for Modem Support
You must make sure to configure the proper modem-related characteristics and
to use the correct cabling. Chapter 2 provides cabling details. Chapter 3 covers
how to set up a port to support dial-in, dial-out, or dial-back capabilities.
Configuring PPP
The basic steps for setting up a server to support IPCP and IPXCP connections
are:
1.
Enable PPP at specific ports, or use APD.
2.
Specify optional PPP PORT characteristics.
3.
Configure the NCP.
After the port has been configured for PPP operation, you must perform
additional steps that are specific to the NCP (IPCP or IPXCP) being
configured. These are covered in the sections
“Configuring IPCP
Connections
” and
“Configuring IPXCP Connections
.”
Enabling PPP at Specific Ports
After you enable PPP on the communication server, you must enable it on
individual ports. This can be done either by setting up the port to accept
multiple protocols with APD (covered in Chapter 2), or setting the port up so
that only PPP is used on it, using one of the following commands:
DEFINE PORT
port-list PPP ENABLED/DISABLED
SET PORT PPP ENABLED/DISABLED
Содержание 3395A
