figure 17 and tighten the fixing screws.
11.2 To remove the complete burner unit.
1.
Remove the firefront and place in a safe position.
2.
Remove the ceramic fuel effect.
3.
Close the valve in the inlet ‘T’ connector / elbow.
4.
Disconnect the appliance from the inlet ‘T’ Connector.
5.
Remove the front leg fastening screw. This is located to the left of the control knob.
6.
Lift the burner out of the fireplace opening.
7.
Replace in the reverse order.
11.3 To remove the pilot unit.
1.
Remove the burner unit (See section 11.2).
2.
Detach the pilot pipe from the pilot unit.
3.
Detach the thermocouple from the gas valve.
4.
Detach the electrode lead from the underside of the
electrode tab.
5.
Remove the two screws securing the pilot unit (See
figure 18).
6.
Refit in the reverse order.
Note:
1.
The pilot unit is an atmosphere sensing device. It must be replaced as
a whole assembly. Its individual components are not separately replaceable.
11.4 To remove the gas valve.
(See figure 19).
1.
Remove the burner unit (See
section 11.2).
2.
If lying the burner on its back,
ensure that the work surface is
suitably protected. This will avoid
damage to the work surface.Turn
the burner unit upside down.
Detach the thermocouple from the
tap
3.
Detach the pilot pipe from the
tap.
4.
Detach the inlet pipe.
5.
Detach the injector pipe
6.
Detach the electrode lead from
the base of the electrode
7.
Remove the control knob by
Page 24
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2006.
Figure 18. Pilot unit removal
Figure 19. Gas valve (Viewed from rear with
burner turned over)
