8.
Underneath the heater,
mark on the wall the position
of the slot in the lower
support bracket.
9.
Lift the heater off the wall.
10.
Drill the marked positions
using a suitable sized drill bit
for the chosen fixings.
11.
Insert the wall plugs /
fixings.
12.
Hang the heater body on
the wall hanging bracket.
Secure the bottom of the
heater using a suitable screw.
Panache and Washington
models.
1.
The surround has six holes
in its base. The top surface of the plinth has six pilot holes. Place the surround onto the
plinth ensuring that the six holes are in line. Secure the surround to the plinth using six
screws supplied (See figure 5).
2.
Place the surround and plinth assembly against the wall ensuring that the electrical
cable is on the required side of the surround.
Fitting the Hanging Deco Fascia.
1.
On the underside of the fascia top are
two sets of pilot holes. Align the holes in
the fascia hanging brackets with the pilot
holes and secure using the screws
supplied (See figure 6).
2.
On the lower rear of the fascia are two
sets of pilot holes. Align the holes in the
fascia retaining brackets with the pilot
holes and secure using the screws
supplied (See figure 6).
3.
Locate the fascia hanging brackets into
those on top of the heater.
4.
Swing the bottom of the fascia in to
place.
Page 9
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2006.
Figure 5.
Figure 6.
