FITTING THE HEATER
The installation of this heater requires a reasonable level of DIY skills.
Please read this guide thoroughly before commencing installation and if in doubt,
seek help from a competent person.
Do I need any tools?
Hanging Deco and Distinction models.
!
A Pozidrive / Phillips / cross head. This should have a number 2 size tip. This is
required for screwing the lower support bracket and the hanging/retainer brackets to the
Hanging Deco fascia.
!
A flat ended screwdriver will be required for securing the wall mounting bracket
and lower support bracket.
!
If drilling into brick work you will need a power drill (preferably with hammer
action) and appropriate size drill bit for the wall plugs supplied.
Panache and Washington model.
!
A Pozidrive / Phillips / cross head. This should have a number 2 size tip. This is
required for screwing the surround to the plinth.
Where can I fit the heater?
Hanging Deco and Distinction models.
The Hanging Deco and Distinction models are designed to be wall mounted on a flat
wall. There should be at least 50mm (2 inches) clearance between the top of the fascia
and anything such as a shelf, fireplace surround or mantel etc. This will allow the fascia
to be lifted off or removed during servicing. To check this gently place the fascia against
the surface to which it is to be fixed. Measure the distance from the top of the fascia.
Panache and Washington model.
The model is designed to be floor mounted on a level flat floor.
Important electrical safety.
The heater must
not
be located in front of or under an electrical socket, the socket must
always be accessible in order to disconnect the heater from the electrical supply for
maintenance and cleaning. On the Panache and Washington models the electrical socket
must not be covered by the surround or plinth.
Page 6
INSTALLER AND OWNER GUIDE
©
Baxi Heating U.K. Limited 2006.
