8.
The sides have a stepped top face. These
must be located on the inside the top piece
(See point 1 of figure 12). The tabs on the
top piece must locate on the inside of the
side pieces (See point 2 of figure 12).
Secure the two side pieces to the top piece
using two self tapping screws supplied.
Locate the screws from inside the ‘U’
channel.
9.
There is a length of self adhesive foam
seal supplied with the fire. This will need
to be fitted to the outer rear edges of the
side and top pieces of the spacer frame.
Ensure that there is no gap between the
foam seals where they meet at the top
flange (See figure 13).
10.
The spillage plate is supplied as a
loose part (See figure 6). The spillage
plate screws (4 off M4 x 10 taptite) have
been fitted to the hotbox.
Remove these, locate the spillage plate
and secure with the four screws (See
figure 14).
The spillage plate MUST be
fitted to the fire.
Page 19
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2007.
Figure 14.
Figure 13. Fitting the foam seal
Figure 12. Fitting the foam seal
Figure 11. Assembling the spacer frame
