2. Unpack the fascia casting and lower into the hotbox as
in figure 24. The side of the casting has slots that locate
over the front of the burner unit (See figure 24). At the
rear of the casting there is a small shelf. This should
locate under the ribbed panel. After locating the casting
gently push the front of the casting.
13. FITTING THE CERAMIC FUEL EFFECT
The installer and owner guide for the ceramic fuel effect is supplied with the ceramic
fuel effect. It is important that the guide for the ceramic fuel effect be placed inside or
attached to this guide and handed to the customer following completion of the ‘final
review’ section.
14. FULL OPERATING CHECKS
14.1 Check the control settings.
Please note:
When first turned on from cold, the flames will appear predominantly blue.
When operating the fire for the first time, some vapours may be given off which could
set off smoke alarms in the vicinity. These vapours are quite normal with new
appliances. They are totally harmless and will disappear after a few hours use
.
14.1.1
Lighting the burner.
Open the isolating valve on the ‘T’ connector. Screw on the end cap and test for leaks.
Depress the control knob and rotate it anticlockwise to the pilot ignition position. A
‘click’ will be heard as the integral piezo operates. A flame should appear at the pilot to
the left hand side of the ceramic fuel effect. When a flame appears at the pilot keep the
control knob depressed and hold the pilot ignition position for five seconds. When the
control knob is released the pilot flame should remain lit.
If there are no sparks check the spark gap between electrode wire and pilot tip.
14.1.2
Operating the burner.
Turn the control knob anti-clockwise to ‘HIGH’ (Depress the knob slightly to get past
Page 25
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2007.
Figure 24. Fascia casting
location
