Baumer OADR 20I6 Series, Руководство пользователя

Страница: 36 / 40

BA_OADR20.doc 36/40 Baumer
12.06.2017 Frauenfeld, Switzerland
Technical data
OADR 20I6465/S14F
OADR 20I6565/S14F
OADR 20I6475/S14F
OADR 20I6575/S14F
OADR 20I6485/S14F
OADR 20I6585/S14F
Function Measuring sensor
Technology Laser Triangulation
Measuring ranges MB
30...130mm 50.....300mm 100...600mm
Resolution typical
0.005...0.06mm 0.01...0.33mm 0.015...0.67mm
Linear deviation (white ceramics)
< ±0.015... ±0.20mm < ±0.03... ±1.0mm < ±0.05... ±2.0mm
Light source Laser diode red, pulsed
Wavelength Red light 650nm
Laser beam diameter (64xx) 2...1mm 2mm 2mm
Laser beam width (65xx) 3...5mm 4...12mm 5.5...21mm
Laser beam height (65xx) 2...1mm 2.5mm 2.5mm
Color sensitivity typ. < 2 x the actual resolution
Suppression of mutual
interference
No active suppression
The synchronization input may be used for asynchronous operation
Temperature drift typical < ±0.03% of MB / °C < ±0.03% of MB / °C < ±0.03% of MB / °C
Ambient light immunity < 40 kLux < 8 kLux < 10 kLux
Measuring rate (depending on
object reflectivity)
300....900us 300....900us 300....2800us
Response time < 2 x measuring rate
Release time < 4 x measuring rate
Power on indicator yes, LED green
Alarm yes, LED red
Voltage supply range +Vs
12 … 28 VDC
Current consumption < 100 mA, (at +24V ~40mA)
Analog output 4...20mA and 0...10V
Load resistor at I-Out < (+Vs - 6V) / 0.02A
Load resistor at U-Out >100k @ +Vs = 12V .
>10k @ +Vs = 15...28V
Alarm output yes (high signal beyond MB)
Alarm output type PNP
Alarm output load current
≤ 100 mA
Voltage drop at PNP
alarm output
max: < +Vs -(4.0V) @ 100mA
typ: +Vs -(2.4V) @ 100mA
Short circuit protection (analog I-
Out, analog U-Out, Alarm-Out)
yes
Reverse polarity protection yes (supply only)
Material of housing Stainless steel 1.4404
Material of front optics PMMA
Material of light guide PMMA
*
1)
and *
2)
measured on white ceramic sheet
*
3)
the response time depends on the reflectivity of the object
For objects with a reflectivity < 7% (OADM 20x2480/S14C), the response / release time is increased automatically
up to max. 2.8 ms.
*4)
Missed measurements up to 30 cycles will be suppressed. During this time the analog output stays on hold.
*5)
xx% of full scale measuring range / °C
*
6)
maximum sunlight on a white measuring surface