Baumer HXC13, Руководство пользователя

Страница: 11 / 38

11
Getting Started 3.
Before starting to operate the camera, make sure that the following equipment is
available:
Baumer HXC13 camera ▪
required lens ▪
Baumer Software CD ▪
Image processing system, e.g.: PC and Software ▪
1 CameraLink ▪
®
cable (2 for Full CameraLink
®
operation)
1 Power supply 12VDC, 0.75A min ▪
1 power cable ▪
Initial Setup 4.
Baumer HighSpeed cameras are delivered with initial parameters and therefore do not
need to be configured via the serial link.
Serial Number and Firmware Revision 4.1.
Serial number and firmware revision is provided in the cameras non-volatile memory.
Use :v command to read serial number and firmware revision. The serial number is also
marked on the type plate of the camera.
PowerUpProfile 4.2.
The PowerUpProfile is the content of all camera registers to be loaded from non-volatile
memory after power up.
Camera profile 4.3.
The actual set of parameters is called Camera Profile. All changes of parameters by the
serial link is reflected in the Camera Profile. On command the Camera Profile is saved to
8 user profiles or the PowerUpProfile. It is loaded from the PowerUpProfile, 8 user profiles
or 8 factory profiles. The camera profile is volatile and must be stored to the PowerUp-
Profile to be reactivated on next power up.
Factory Profiles 4.4.
The factory profiles can be read but not written by the user. They are factory preset to the
settings described below.
Profile
No.
Video Data
Width
[Mbytes/sec]
Resolution Full
Frames
[max. fps]
Mode Camera
Link Con-
figuration
Pixelclock
[MHz]
0 148 640 x 480 405 2x10 Base 80
1 172 1280 x 1024 110 2x10 Base 80
2 119 640 x 480 405 2x8 Base 80
3 138 1280 x 1024 110 2x8 Base 80
4 297 640 x 480 811 4x10 Medium 80
5 353 1280 x 1024 226 4x10 Medium 80
6 468 640 x 480 1599 8x8 Full 80
7 540 1280 x 1024 432 8x8 Full 80