Baumatic BMEH94E1G, Инструкция по использованию и установке

Страница: 8 / 32

8
A ISO7-1 R1/2 connection plug
B Non-metal gasket with thickness of 2 mm
C Pipe adapter for liquid gas (depending on the model)
Only use pipes and seals in accordance with the Standards . These pipes must be
installed so that, when fully extended, their length does not exceed 2000 mm. For easier
installation and to prevent gas leaks, attach the swivel coupling to the cook top first, and
then to the gas mains pipe. Inverting this sequence may hamper the gas seal between the
pipe and the cook top.
Important: when the installation is complete, check that all couplings are completely
sealed by using a soapy solution. Never use a flame. Also ensure that the flexible
pipe cannot come into contact with any moving part of the cook top (e.g. drawer) and
that it is not in a position where it could be damaged.
After the connection, check the burners for correct operation.
The flames must be clearly visible, and should be blue and green at the center. If the flame
is unstable, increase the minimum power.
Adaptation to a
different type of gas
• The procedure or adaptation of the cooker to another type of gas does not require removal
of the appliance from the worktop.
• Before adapting, disconnect the appliance from the power mains and close the gas supply
valve.
• Replace the existing nozzles for nominal thermal load with corresponding nozzles for the
new gas type and supplied provided (see table below).
• After finishing this sequence, replace the old setting label with the new one provided for
the new injectors.
Minimum flow
adjustment Instructions for town (G110, G120, G150.1) and methane gas (G20, G25)
1. Light the burner and bring it to the minimum position.
2. Remove the gas tap knob and turn the adjustment screw on the side of the tap rod, until
a regular minimum flame is obtained:

anti-clockwise to increase the gas flow

clockwise to reduce the gas flow
3. Re-assemble the knob and verify burner flame stability (when quickly rotating the hand
from maximum to minimum position the flame must not shut off).
4. Repeat the operation on all gas taps.
Instructions for liquid gas (LPG: G30, G31)
Tighten the screw on the side of the tap, rod clockwise completely.